Mossy Oak Graphics

[jdavenp3]

What would you say will be the most difficult? If I cut around the ribs? Or just the time it takes to cut out the push pins and all of the small stuff?

[Old Gobbler]

I just layed it over the action pins , didn't bother cutting those out , when I have to service the gun , I'll cut them out then , I guess

[Borden811]

I cut the action pins out, didn't take but a few seconds. The most time consuming part for me was using the heat gun and getting it laid down around the curves without any wrinkles. I didn't do my rib. It really wasn't hard, just time consuming. Give it a shot, you'll be glad you did.

[jdavenp3]

Best place to order it directly from Mossy Oak? I have some Cabela's points but don't see it on there anywhere...

[Old Gobbler]

I would presume , the manufacturer has the best inventory on hand - it took about 2-3 days to get it -

[camodawg]

I just layed it over the action pins also. And I stopped the wrap at the vent rib. That was the easiest and it still looks good to me.

[jdavenp3]

They actually DO have these at Cabelas if anyone is looking. $30 but limited to Mossy Oak Infinity and Duck Blind.They also have scope wraps as well for those of you with mounted optics.

Since I have a few dollars built up there I will probably go with the Infinity kit.

Link is below if anyone was wanting to check them out. 15 reviews with a 4.8 star rating. Seems like everyone enjoys them.

http://www.cabelas.com/product/Shooting/Gun-Storage/Sleeves-Camo|/pc/104792580/c/104730480/sc/104576580/Mossy-Oak174-Graphics-Gun-Skins/1423647.uts?destination=%2Fcatalog%2Fbrowse%2Fsleeves-camo%2F_%2FN-1100214%2FNs-CATEGORY_SEQ_104576580%3FWTz_l%3DSBC%253BMM%253Bcat104730480&WTz_l=SBC%3BMM%3Bcat104730480%3Bcat104576580

[fountain2]

Made a separate thread, but I will ask here.  I have a 20 Ga 870 and would like to do this to.  I have a set of Boyds thumbhole stocks and for end.  Is there enough material pre cut to do that stock?

[jdavenp3]

Do you think your aftermarket stocks have more or less surface area than the original stock?

[fountain2]

I'm guessing more

[TBab]

 

[willy8457]

I did my Stoeger 3500 and it looks good, this will be the second year I hunt with it.

[the Ward]

I watched the video, and one thing I was wondering is how to do the seams. Do you cut them like you would when wallpapering or just leave them overlapped? They mentioned something about cutting a wavey line but not whether you pull up the cut from underneath or not, like you would when seaming wallpaper.

[the Ward]

Just ordered a kit, wife shops a lot on Amazon, they have them for $22.66. I never thought to look there! Got the bottomland, but they have the other patterns also.

[jblackburn]

dang, that looks good!  I might have to give the old 835 viking a facelift!