Russian Shell Crimpers

[mtns2hunt]

Has anyone used some of the Russian Shell Crimpers being sold on e-bay? Some of them look rough but there is a stainless steel one that looks good. I was also wondering about the hand crimpers and if they really work, Looks like they are selling well so thought someone on here may have some knowledge. Thanks

Roll Crimper 12 GA Shotshell Reloading Stainless Steel FC

Roll Crimper Hand Tool for Shotshell Reloading 20 GA, zr20

[Clydetaylor1]

RUSSIA, RUSSIA.!!!  Better not let CNN hear of it.?

[tree-rat sniper]

RUSSIA, RUSSIA.!!!  Better not let CNN hear of it.?

LMAO!! 

[mtns2hunt]

RUSSIA, RUSSIA.!!!  Better not let CNN hear of it.?

That is funny! I am not very political and have never had any bias against the Russians and I am not looking to buy a S400. Just a shell crimp. So anyone have any experience with Russian shell crimpers.

[Gobble!]

https://www.ebay.com/itm/Roll-Crimper-Hand-Tool-for-Shotshell-Reloading-20-GA-zr20/253832577094?epid=4023071254&hash=item3b1999c046:g:c2AAAOSwB-1Yvo-6

I used that one in the past. Does a fine job but I prefer a drill press. Would like to try to the other type that you can tighten down to a table but they don't make a 3.5" model.

[mtns2hunt]

https://www.ebay.com/itm/Roll-Crimper-Hand-Tool-for-Shotshell-Reloading-20-GA-zr20/253832577094?epid=4023071254&hash=item3b1999c046:g:c2AAAOSwB-1Yvo-6

I used that one in the past. Does a fine job but I prefer a drill press. Would like to try to the other type that you can tighten down to a table but they don't make a 3.5" model.

Thanks for the feedback. I was mainly curious about this one as a back up. I have a drill press so that will be my first choice.

[Gobble!]

https://www.ebay.com/itm/Roll-Crimper-Hand-Tool-for-Shotshell-Reloading-20-GA-zr20/253832577094?epid=4023071254&hash=item3b1999c046:g:c2AAAOSwB-1Yvo-6

I used that one in the past. Does a fine job but I prefer a drill press. Would like to try to the other type that you can tighten down to a table but they don't make a 3.5" model.

Thanks for the feedback. I was mainly curious about this one as a back up. I have a drill press so that will be my first choice.

Solid back up choice and worth the cost IMO.