OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

only use regular PayPal to provide purchase protection

Main Menu

Looking for a Wincgester Long beard 20ga

Started by Fullfan, May 13, 2018, 01:30:57 PM

Previous topic - Next topic

Fullfan

Looking for a new/use  Winchester shotgun long beard in 20 ga. If anyone can point me in the right direction I appreciate it.
Don't gobble at me...

mike103


Fullfan

Thanks, Winchester has released some. Have two scheduled for delivery next week.
Don't gobble at me...

ShootingABN!




Fullfan

#6
Yes I did pick it up last week. Mounted a FF3 and screwed in a .555 Indian creek choke. Last night at 41 yds It put 361 in the 10". Never thought I would say it, Pattern is to tight for my liking with not much wiggle room.  Did some chatting with Reloaded and he suggested a .585 in either a Truelock or Carlson's, I have a Truelock on the way.   May send the trigger off to have some work done, it has some creep and is prob a 7 pound pull.

The 365 was with a 3" 1 5/8oz hand load of TSS #9  ( Lil Hammer load) 

Don't gobble at me...

10gaugemag

Where are you sending your trigger group? I would like to get the trigger done on my new Bottomland SX3 20 gauge.


ltprod

Quote from: 10gaugemag on June 15, 2018, 07:07:41 PM
Where are you sending your trigger group? I would like to get the trigger done on my new Bottomland SX3 20 gauge.


Sx3 bottomland
Factory job??


Sent from my iPhone using Tapatalk

10gaugemag

Yes it is. Picked it up a few weeks back.

Had a guy list a couple chokes I was interested in but somebody snagged those up in a New York minute!!




Fullfan

Quote from: 10gaugemag on June 15, 2018, 07:07:41 PM
Where are you sending your trigger group? I would like to get the trigger done on my new Bottomland SX3 20 gauge.

Good chance it will go to Rob Roberts, have heard some good things about his service and a fast turn around.
Don't gobble at me...

10gaugemag

Quote from: Fullfan on June 15, 2018, 08:34:54 PM
Quote from: 10gaugemag on June 15, 2018, 07:07:41 PM
Where are you sending your trigger group? I would like to get the trigger done on my new Bottomland SX3 20 gauge.

Good chance it will go to Rob Roberts, have heard some good things about his service and a fast turn around.
That's where I am thinking about sending mine. He did a Browning for a buddy and I am thinking did his M2 as well.