Camo dipping. Who do I get...?

[Snoodsniper]

I had tarjac dip my gun and it's held up great. The barrel that Rob Roberts did for me has held up just as well.

The only negative I have about that barrel is there were a couple spots of the base coat showing but it was really minor.

The RR dipped barrel on the Tarjac dipped gun matches perfectly. There's no shine to the finish whatsoever.

[sixbird]

Thanks gents...I'm leaning toward Tarjac. A little more expensive but I'm doing this once...

[ShootingABN!]

Thanks gents...I'm leaning toward Tarjac. A little more expensive but I'm doing this once...

Going to post up once you get r done.

[Hunt4spurs87]

Check these guys out absolutely outstanding work Carolina hydro graphics Conway SC


Sent from my iPhone using Tapatalk

[MissLouHunter]

I used Don at CamoSolutions about 4-5 years ago. Got the flat finish in the USMC Digital pattern.

Still love it, very little wear marks.

[dms2511]

No question, TARJAC. Additionally, they now offer the "soft touch"finish.

[sixbird]

Thanks everybody!

[ShootingABN!]

Have you sent it off to get-R-done yet?

[sixbird]

Haven't yet. Need to wait a few weeks...

[WV Ridge Reaper]

Check these guys out absolutely outstanding work Carolina hydro graphics Conway SC


Sent from my iPhone using Tapatalk

I'll lay 100 doll hairs on tad vs anyone


Sent from my iPhone using Tapatalk

[Hunt4spurs87]

Check these guys out absolutely outstanding work Carolina hydro graphics Conway SC


Sent from my iPhone using Tapatalk

I'll lay 100 doll hairs on tad vs anyone


Sent from my iPhone using Tapatalk

Yessir he does outstanding work


Sent from my iPhone using Tapatalk

[ShootingABN!]

Excited to see the finished work.

[sixbird]

Finally found my window for this camo job. In researching the companies, I found that Camo Solutions takes the existing finish down to bare metal and plastic. He primes the parts according to the requirements for that material and finishes with the hydro dip.
He actually takes the firearm down (in my case, takes insert out) and protects the internals from getting wet. He dries everything with air after the finish.
He sounds like he's squared away and thorough.
This, and a friend had his gun done by Don and was VERY happy with it.
My only disappointment was his schedule. It's a double edged sword. He's backed up for a month and a half and the process will take 30 some days, so it'll be a little while.
The other edge of this sword is that, if he's that busy, he must do good work...
I'll post when I get it back...

[ShootingABN!]

Did you say what pattern you are going with???

[birdhunterdave]

Tarjac did an awesome job for me,would definently use them again!