Magnum Blends 5x6x7 ?

[unclerick]

I just got a box of these shells to use in my run-n-gun Mossberg, my question is to you guys that know about such things is, the only choke I have for it is a factory Remington Super Full, will it do for these loads and work good or should I use something else. This gun was a project/parts gun that I customized for home defense, I had the barrel cut and threaded to use Remington chokes, I do have a Tru-glo and Tight wad I can use in it if I can get them back. Any help is appreciated. Thanks

[msgobblergetter]

What length barrel?  You should be fine with Rem Super Full and magblends, but I bet the tight truglo would do even better if its the ssx model.

[unclerick]

The barrel is 19 1/2in with out the choke, shooting Remington loads from it patterns pretty good. So you think it will be OK, I'll get the other chokes from my brother.

[GOLD HUNTER]

just go and shoot the gun with that choke ans see what it looks like 

brian

[hunttherut]

No way to know for sure until you pattern it.

[msgobblergetter]

You should be alright, but watch out, they kick like two mules!

Camo is right... they don't play.  I'd opt for the 3" magblends

[allaboutshooting]

I just got a box of these shells to use in my run-n-gun Mossberg, my question is to you guys that know about such things is, the only choke I have for it is a factory Remington Super Full, will it do for these loads and work good or should I use something else. This gun was a project/parts gun that I customized for home defense, I had the barrel cut and threaded to use Remington chokes, I do have a Tru-glo and Tight wad I can use in it if I can get them back. Any help is appreciated. Thanks

I believe the Remington Super Full is a flush mounted lead only choke, correct? If so, I'd try those other chokes with your gun. That SF choke is very good with #6 lead however.

Thanks,
Clark

[chcltlabz]

The Remington Super Full is an extended non ported tube, and yes it is labelled for lead only.  My tube at least was made long before any high density shells though, so I think it was meant to keep folks from shooting large steel shot through it.

I wouldn't tell you to shoot anything other than lead through that tube, but my 870 in 3 inch with the same tube shot 184 hits at 40 yards with the Mag Blends and 40 degrees.

[3" 870 Shell Shucker]

There have been both Lead Only, and Hevi Shot Approved versions of the Remington Super Full Choke.  Both versions seem to be very strong, tough, non-ported chokes that will stand up to just about anything.  Probably a very safe bet with HTL.

[unclerick]

Well I went out today and shot both my turkey guns, in the 11-87 with the JH 665 and Heavy-13 was not impressive at all, I was expecting a tighter pattern at 40yrds but it actually was a little less then shooting the Winchester extreme extended range shells. The Mossberg patterned ok with the 5x6x7 magblends but was low and hurt like heck.

I'm curious how some of you guys get over 100 pellets in 10ins at 40yrds, I'm lucky if I get half that many.

[knightrider]

i get it done with polished barrel and pure gold choke, if you want the numbers you have to play the game all the way through

[coyotetrpr]

I am using the hevi 13 choke tube with good results

[hookedspur]

just go and shoot the gun with that choke ans see what it looks like 

brian

[sugarray]

Are you drawing your circle AFTER you shoot?  You just may not be getting the most dense core of your pattern.  The Xtended Range are great shells as well, if they do better, then use them.  What are your 40 yd numbers?

[bowhunter84]

just go and shoot the gun with that choke ans see what it looks like 

brian