Woodhaven Surface Savers

[Cutt]

Anyone using these surface savers for pot calls? Was wondering what the I.D. of the lids are, or what range of call diameters will they fit? Thanks

[WNY Bowhunter]

Small Folgers coffee lids work also...

[Wildfowler]

I use them a lot and will fit on Halloran pots and Darrin Dawkins pots, a few others but most of my customs are either a hair to big or small for the lids

[packmule]

I use them and like them.  If they are a hair too small you can heat them up with a hair dryer and then put them on your call and allow them to cool, creates a custom fit.

However, if I were to buy any more surface savers I'd go with the ones from Enticer:

http://www.enticerturkeycalls.com/shop/accessories/enticer-call-cover/

[Cutt]

I use them and like them.  If they are a hair too small you can heat them up with a hair dryer and then put them on your call and allow them to cool, creates a custom fit.

Do you know I.D. of the lid? They do not give this measurements anywhere, which would be nice, so one would know which calls they would fit? Thanks

[perrytrails]

I use them and like them.  If they are a hair too small you can heat them up with a hair dryer and then put them on your call and allow them to cool, creates a custom fit.

However, if I were to buy any more surface savers I'd go with the ones from Enticer:

http://www.enticerturkeycalls.com/shop/accessories/enticer-call-cover/

The Enticer covers fit great!!

[sbbow]

can cuzy is what I use.

[Cutt]

Anyone using these surface savers for pot calls? Was wondering what the I.D. of the lids are, or what range of call diameters will they fit? Thanks

Never did get a response to the question? So bought a couple to find out for myself.

If anyone else is wondering what the size of these lids are? They have a I.D. of 3.75", so in other words they will fit potcalls with roughly a 3.7" to 3.8" outer diameter. Then again it did take a couple seconds to measure?

[tomstopper]

I use them and like them.  If they are a hair too small you can heat them up with a hair dryer and then put them on your call and allow them to cool, creates a custom fit.

However, if I were to buy any more surface savers I'd go with the ones from Enticer:

http://www.enticerturkeycalls.com/shop/accessories/enticer-call-cover/

The Enticer covers fit great!!

Yep just bought two myself.

[PALongspur]

Can anyone tell me what size calls (a measurement would be nice) that the Enticer covers will fit?

Thanks!

[packmule]

The i.d. on mine are 3 5/8"...they fit all of my 3.5" pots well.  The material is much more flexible than the Woodhaven model. 

[model94]

Enticer lids will not fit Lonnie Sneed ' s calls.  The lids are too big.