It takes about an hour to make and only cost me $32 inculding paper and tax.
Materials needed(Home Depot):
2- 1" PVC Elbows(.44 each)
2- 1"x1"x1" PVC Ts(.56 each)
2- 1"x1/2"x1" PVC Ts(.93 each)
1- 1/2" SC40 PVC Conduit joint 10' (1.09 each)
2- 1" SC40 PVC Conduit joints 10' (2.30 each)
1- Box of 100 #8x1/2" round head sheet metal screws(2.87 each bx)
1- 4" PVC Drain pipe 10' (7.82 each)
1- 35" wide 140 ft roll of contractors paper(9.97 each) (in the paint section)
1- 1x6 fence picket (cheap)
2- Paper clamps(had them on hand, have no idea what they cost)
Cut 2 1" conduits 37-1/4" long
Cut 1 1" conduit 37" long
Cut 1 1/2" conduit 37-1/8" long
Cut 4 1" conduits 10-12" long
Cut 2 1" conduits 2-1/8" long
Cut 1 4" PVC piece 36-3/4" long
37-1/4" 1" pieces are the sides
37 1" is top
37-1/8" is the paper roll axle
4-10" pieces are the feet
2-1/8" piece are just connections from the 1x1/2x1 tees to connect the feet Ts
Assemble all PVC, Square, drill pilot holes slightly smaller than #8 screw at every joint(3 per Tee), screw a screw in every joint hole, cut a slit all the way down the 4" 36-3/4 pipe, insert paper roll and while inserting pull tab of paper through slit and slide roll into pipe, unscrew one side of 1/2" axle and pull from joint, slide paper roll/4" pipe onto axle, reinsert axle in T, replace screw into axle, Drill 3/8" hole in one side of clamp, drill 1/8" hole in other side of clamp, remove one clamp arm on the small hole side, level clamp on top 2" back from elbow, mark through big hole and little hole onto the pipe, drill small pilot hole at marks, insert screw through 3/8 hole and screw to top pipe, cut fence picket 36-7/8"
I did not glue anything incase something breaks you can just replace one piece instead of the hole thing.
Once you set up the target stand prop fence picket 1x6 against the 4" PVC to keep stray pellets from busting the pipe. You now have a sweet target stand that's light weight and beats the heck out of moving a 3/4" sheet of plywood around. I have a portable Big Game shooting bench and this set-up is easy to move around to get out of the wind, find a shady spot, take to the camp, etc etc.....
Here's the finish product less the fence picket:
Back:
Front:
Ya'll have a Good One,
Reloader
