835 and FF3

[Kbota]

So, I recently bought a new Mossy 835.  Factory sights are horrible.  Just bought a picatinny rail and mounted on it.  About to order the FF3 with protector mount.  If I want to be able to move thie FF3 from this gun to maybe an AR, do I order it with the mounts?   If i do that, Will it fit the protector mount?   I'm just a tad confused about which arrangement to order. 
Help is appreciated.

[Kbota]

Anyone have a suggestion?

[CrustyRusty]

I'm a bit confused by your question but will try to answer.  If you get the protector, it is should be fine for use on any pic rail since it is a mount.

[Kbota]

Thank you Rusty.  I guess my question wasn't well worded.   If I intend to buy the protector mount, do I order the ff with or without the built in mounts?   In other words, how does the ff mount to the protector mount?

[Otdrzman]

Get the FF3 with no mount (Part No. 300235, 3 MOA dot or Part No. 300237, 8 MOA dot). Get the Picatinny Protector (Part No. 410330). The FF3 mounts to the top of the picatinny protector with two screws and lock washers. I just installed the same set up on my 835. I actually cut the picatinny rail in half and only used the back two holes. Hope this helps.

[CrustyRusty]

The sight is held onto the mount with 2 screws. Normally i would say just get the sight and protector mount separately but cabelas has the ff on sale with a picatinny mount. I just bought one because of the sale and will be picking up the protector mount later.   I felt it couldnt hurt having the spare pic mount. Good luck