putting feathers on soundboards?

[Swamp]

Do you super glue them or what? Gonna turn a walnut pot tomorrow and do glass over glass and want to put a feather on the sound board.Will be my first attempt at a pot call.  Thanks for the help

- Ben

[Cut*N*Run]

I've only done one but I put a nice drop of the gel super glue on the base of the stem and it came out perfect.

[lightsoutcalls]

I use plumbers goop for my soundboards and surfaces, so I take the nozzle top off of the tube, touch the feather stem to the little curl of glue that is sticking out.  If you can see even a tiny bit of shiny glue on the feather stem, you have enough.  I then place the feather on the soundboard and place a small wood cutoff  (about 1"x1"x2") on the feather above where the glue was placed.  Let it sit for a couple of hours and it will be good to glue into your call.

[Swamp]

thanks for the help guys.

-Ben

[TarheelTurk]

I use plumbers goop for my soundboards and surfaces, so I take the nozzle top off of the tube, touch the feather stem to the little curl of glue that is sticking out.  If you can see even a tiny bit of shiny glue on the feather stem, you have enough.  I then place the feather on the soundboard and place a small wood cutoff  (about 1"x1"x2") on the feather above where the glue was placed.  Let it sit for a couple of hours and it will be good to glue into your call.

X2 works Great !!

[handcannon]

Same here with the goop. I use a syringe and put a dab at the base and a dab in the center. Position it and press it in place. Make sure it is flat so it does not touch the striking surface above. I dont know if it would affect the call but its best to keep it flat.