BPS factory base fit issue...

[mudhen]

Setting up my new NWTF BPS with the factory one-piece base #12360.

Can't get the post to seat in the base.  Has worked fine on other Weaver/Picatinny bases.  Maybe just a matter of a bit of fine sanding on the base?  Maybe the coating is too thick?

Any suggestions?

I like how the factory base attaches, with part of it covering the vent rib, so I don't want to use a different base just yet.

Thanks!

mudhen



http://www.browning.com/products/catalog/accessories/detail.asp?fid=018J&cid=123&tid=187E&bg=x