Franchi Rail Screw Hole Plug Search

[Trkmaster88]

Hey does anybody have any of the factory plastic screw holes plugs laying around they'd part with? I am looking for 4. Thanks!

[Gmed]

I believe they are 8-40 thread. You can order the little flat head blank filler screws from Brownells...

https://www.brownells.com/gunsmith-tools-supplies/small-hardware/metal-screws/plug-screw-kit-prod792.aspx

[Trkmaster88]

I believe they are 8-40 thread. You can order the little flat head blank filler screws from Brownells...

https://www.brownells.com/gunsmith-tools-supplies/small-hardware/metal-screws/plug-screw-kit-prod792.aspx

Thank you, and you are correct. Looking for the factory plastic ones. I feel they provide a cleaner look.

[lacire]

If my calipers and math are correct 8-40 screws are .16" in diameter = 4mm. I've never removed the ones in a Franchi receiver so the length and head diameter on these may be wrong, but take a look, may work may not. Somebody else may be able to point you in a better direction. If these should work for you please post back so anybody else looking will know. Good luck.

https://www.amazon.com/uxcell-Furniture-Plastic-Drilling-Insert/dp/B00X77ICCQ

[Trkmaster88]

If my calipers and math are correct 8-40 screws are .16" in diameter = 4mm. I've never removed the ones in a Franchi receiver so the length and head diameter on these may be wrong, but take a look, may work may not. Somebody else may be able to point you in a better direction. If these should work for you please post back so anybody else looking will know. Good luck.

https://www.amazon.com/uxcell-Furniture-Plastic-Drilling-Insert/dp/B00X77ICCQ

Thanks for the link. I checked them out and the head diameter on there would be about twice as large (8mm vs a little over 4mm).

[lacire]

If my calipers and math are correct 8-40 screws are .16" in diameter = 4mm. I've never removed the ones in a Franchi receiver so the length and head diameter on these may be wrong, but take a look, may work may not. Somebody else may be able to point you in a better direction. If these should work for you please post back so anybody else looking will know. Good luck.

https://www.amazon.com/uxcell-Furniture-Plastic-Drilling-Insert/dp/B00X77ICCQ

Thanks for the link. I checked them out and the head diameter on there would be about twice as large (8mm vs a little over 4mm).

Yah it's been awhile since I saw them and didn't remember how big the head was. Have you tried to contact Franchi?