Stevens 301 20ga stock choke?

[YukonC]

• Tweet

Anyone have any pattern pictures with the stock choke and federal tss 9s?


Sent from my iPhone using Tapatalk

[turkeykirk]

• Tweet

Here’s one from mine at 40 yards.


Sent from my iPhone using Tapatalk

[YukonC]

• Tweet

Here’s one from mine at 40 yards.


Sent from my iPhone using Tapatalk

Well that proves to me I don’t need to spend the extra as I normally would on an Indian creek!


Sent from my iPhone using Tapatalk

[WV Ridge Reaper]

• Tweet

Coming from a hand loader..that’s one hell of a pattern!!!


Sent from my iPhone using Tapatalk

[cknpro1]

• Tweet

Stock on the bottom,Carlson’s .560 tss on top, #7 TSS


Sent from my iPad using Tapatalk

[YukonC]

• Tweet

Good enough for me! No need to waste the money.


Sent from my iPhone using Tapatalk

[cknpro1]

• Tweet

Good enough for me! No need to waste the money.


Sent from my iPhone using Tapatalk

Apparently these stock Stevens are known to vary. Mine measured .580, I’ve heard of some .010-.015 variances, so it might serve to check yours. These shots were at 38 yards, and I agree, I’d feel fine with either.
I kept the Carlson in since I paid for it. But I might do some comparison on other loads later. I did shoot a light field load 7 1/2 at about 15 yards with it and it dang near blew a 8” hole in the paper! IMO, you could use a high brass 2 3/4” #6 field load and take a turkey easily at 25, maybe 30 yards.


Sent from my iPad using Tapatalk

[TRex18]

• Tweet

I have a stock NEF 20 gauge. I dont nkow what it is. I was going to run some TSS 7s and 9s through it. it is not threaded.

Any idea  what will happen? Should i get it threaded?

[owlhoot]

• Tweet

I have a stock NEF 20 gauge. I dont nkow what it is. I was going to run some TSS 7s and 9s through it. it is not threaded.

Any idea  what will happen? Should i get it threaded?

I wouldn't. Until I shot it as is.
I have a Winchester 37A that is fixed full and it shoots Federal TSS 9's at 225 or so in the 10" at 40 yards.

[crow]

• Tweet

I have a stock NEF 20 gauge. I dont nkow what it is. I was going to run some TSS 7s and 9s through it. it is not threaded.

Any idea  what will happen? Should i get it threaded?

I wouldn't. Until I shot it as is.
I have a Winchester 37A that is fixed full and it shoots Federal TSS 9's at 225 or so in the 10" at 40 yards.

 , I had an older savage that shot 8's great and 7"s really good.
your not going to hurt your choke if that is what your also asking, besides how it will pattern.