Hopefully this will help ya. But,...This is certainly NOT the only way you can turn a pot.
Just the way I do it.
1st) Find center in your blank. I use a forsner bit to make the center of my pedestal.
Then trim off the corners. Use this chuck, and by expanding, hold the pot. Do the
Outside of your pot first.
![](http://i157.photobucket.com/albums/t62/Mastevt/call%20tutoral/20170329_134159_zpsrkdotxyl.jpg)
![](http://i157.photobucket.com/albums/t62/Mastevt/call%20tutoral/20170329_134542_zpscado0seh.jpg)
![](http://i157.photobucket.com/albums/t62/Mastevt/call%20tutoral/20170127_163023_zpsgw0jq1yt.jpg)
2nd) Find an old motorcycle inner tube. Make a wide rubber band, and use it to protect
your pot from the jaws of the next chuck.
![](http://i157.photobucket.com/albums/t62/Mastevt/call%20tutoral/20170329_144534_zps6rxqrwk7.jpg)
Change out your chuck, and hold your pot from the outside, and turn the inside.