Turkey hunting forum for turkey hunting tips

Turkey Calls => Mouth Call Making Discussion => Topic started by: MRS on June 30, 2021, 07:55:31 PM

Title: Making the cuts
Post by: MRS on June 30, 2021, 07:55:31 PM
Anyone know of or would be willing to make a step by step video on
How to make the cuts of the batwing cut.
Title: Re: Making the cuts
Post by: GobbleNut on July 02, 2021, 09:51:19 AM
Sounds like another project for Ben (compton30) to pursue! 

...Simply stated, the batwing is basically just a center V-cut with the side tabs either cut off or pulled off.  That is pretty obvious, so I am guessing that your question relates to how you hold the call with one hand and cut with the other?  That can be done, but it takes some dexterity.  I don't make many batwings, but if I did, I think I would devise some sort of small vice-like dealybob to hold the call so I could cut the tabs with one hand while holding them with the other. 

As it is, when I decide to make a batwing, I just pop the tabs off by just grabbing them and yanking them off.  Granted, that is not the most precise method of accomplishing the task, but it will work in a pinch.   :D ;D
Title: Re: Making the cuts
Post by: MRS on July 03, 2021, 08:23:32 AM
 Big fingers are getting in the way to make a nice cut line like production calls
I did reverse my cut direction and that seemed to help.


A clamp or small vise like a  fellow mentioned on another post might be the solution for me too
Title: Re: Making the cuts
Post by: SCGobbler on July 04, 2021, 11:47:02 PM
I started using a small clamp from harbor freight to clamp the call to the edge of my table. The problem is the figuring out how you are going to cut the tabs off when the tVle gets in the way of your scissors.


Sent from Gobbler’s Branch on the go!
Title: Re: Making the cuts
Post by: MRS on July 05, 2021, 04:56:06 PM
I have gotten alot better by not making any cuts till after I apply tape to the call, this gives me more material to hold onto.

Title: Re: Making the cuts
Post by: compton30 on July 09, 2021, 12:30:51 PM
Sounds like another project for Ben (compton30) to pursue! 

...Simply stated, the batwing is basically just a center V-cut with the side tabs either cut off or pulled off.  That is pretty obvious, so I am guessing that your question relates to how you hold the call with one hand and cut with the other?  That can be done, but it takes some dexterity.  I don't make many batwings, but if I did, I think I would devise some sort of small vice-like dealybob to hold the call so I could cut the tabs with one hand while holding them with the other. 

As it is, when I decide to make a batwing, I just pop the tabs off by just grabbing them and yanking them off.  Granted, that is not the most precise method of accomplishing the task, but it will work in a pinch.   :D ;D

Coming up!