OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

Winchester SXP Longbeard and Longbeard XR 3.5 #5s and three different chokes

Started by Thad, February 28, 2018, 11:06:37 AM

Previous topic - Next topic

Thad

Shot my SXP with Winchester 12ga. using Longbeard XR 3.5 in #5s and here are the results with three different choke tubes:

Conditions:
75 degrees with light wind.
barrel swabbed with a boresnake between shots
shots taken from a ledsled at 40 yards
pellet hits counted in a 10 inch circle

#1 Jebs Headhunter .650
170

#2 Carlsons Heavyshot .664
166

#3 Kicks Gobblin Thunder .680
134

What do y'all think?

zelmo1


Thad

My fault this is the regular SXP not the  model that comes with that choke, so no.

However I did some research and the Carlsons Longbeard choke which i think is the one in question is a .665 and the one I tested is a .664.  I called the company and asked what the difference was and the guy pretty much said marketing.  I would not expect much of a difference in pattern.


cibor

Sounds good to me, was the pattern even/without holes?

This is what my SXP managed:

Temp 67 degrees
Hevi shot #7
40 yrds

Strangler .665 - 10" circle - 189

-Scott T.

tracker#1

I have a picture posted using a long beard Carlson's choke .665  It patterned better then stock choke in my opinion, someone just posted on forum it looked good for #5s LBs