CZ Bobwhite

[Chickenlips]

Just finishing up my 28 gauge CZ Bobwhite.  I installed a Grove Tec sling swivel kit today.  I made an rmr mount, drilled and tapped my rib, and installed a Holosun 407.  Ended up vinyl wrapping it with OG bottomland. The gun shoots good, POI is spot on.  I'm using a .515 Trulock in the left barrel and a modified Trulock in the right, both extended versions.  I'm shooting Fiochii TSS 1 1/16 ounce 9's.  178 pellets in a 10" circle at 40 yards.  My short barrel shot a nice even 16" round pattern at 30 yards.  I may try some 1 3/8 9.5 Apex in my long barrel to see if I can improve my numbers at 40 but completely happy with what I have.  I would like to thank some of the members of this site for shortening my side x side learning curve.  Especially Crow and Doc Holliday.  If I can figure it out I'll try to post pics.  Thank you

[Spring Creek Calls]

Would love to see it. PM'd you some info if needed.

[Chickenlips]

Would love to see it. PM'd you some info if needed.

Thank you, I'll check it out

[Spring Creek Calls]

Pics

Sent from my SM-A156U1 using Tapatalk

[Dtrkyman]

Awesome build, love the looks of a sxs, details on rib mount?

[Chickenlips]

Awesome build, love the looks of a sxs, details on rib mount?

I also muskie fish and  made my own rod holders.  I have pieces of 3/16" and 1/4" aluminum flat bar left over from that.  I just cut the flat bar to fit my RMR reflex sight.  Not sure if it was right or wrong but I drilled 3 #6-48 holes into my rib for added strength. I thought about filing a groove the width of my rib down the middle of the mount but decided not to.  Seems to be good and solid.  I own a drill press, combination sander, and a set of calipers and like to piddle with what I can.  Thank you for the kind comments