OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

only use regular PayPal to provide purchase protection

Main Menu

20 gauge hull trimmer

Started by Rkeifer, April 07, 2023, 03:06:43 PM

Previous topic - Next topic

Rkeifer

I just purchased some TSS to load my own shells. I have a Benelli M2 in 20 gauge and it is my understanding that I will need to trim the hulls a bit in order for the gun to cycle them. Please advise as to what hull trimmer works best.  Also, if there is a diy option, please let me know. Thank you

Fullfan

I have a GAEP hull  trimmer, I know a fella by the name of Dale Wildman sells GAEP products.  If you want his contact info I can DM you.  He is located is SW Pa
Don't gobble at me...

Fullfan

Don't gobble at me...

Bingoman


Ranman

I measure and mark how much I need to trim, slide a piece of Pex water pipe inside the shell and cut with a razor knife. Pex fits in the 20ga hull perfectly. I lay it on the edge of my work table with the base of the shell off the edge and roll as I cut. Kind of crude, but make a nice cut for roll crimps.. of course you can always buy a shell trimmer, but I'm just a tight wad..
Randy

troutfisher13111

Quote from: Fullfan on April 07, 2023, 07:32:14 PM
I have a GAEP hull  trimmer, I know a fella by the name of Dale Wildman sells GAEP products.  If you want his contact info I can DM you.  He is located is SW Pa
Same thing I used. I don't see anything working better than one of these.


Sent from my iPhone using Tapatalk