Wingbone Joint Transition Filler??

[Brwndg]

Wingbone Filler between Bones?

What do you all use to fill in the transition between bones to smooth them out?

I read somewhere Lumber epoxy putty. Any other ideas?

[runngun]

I use 10 minute epoxy and I mix it up a little thick. Use a popsicle stick to press it in the joints. Then I will start building up next to the joints with colored sewing threads and wrap it like crazy.  I have used red, white and blue thread for some that I made for a friend who is a Retired Marine. Then I did several with purple and gold threads "LSU" colors. I built the threads up and then layer on the epoxy.  Make sure that you clean the bones really well and clean out the inside of the bones with a dremel tool. Do a dry run fitting them together and make a small mark with a pen so you know what fits where. Good luck Bud!!!

Have a good one and May God bless y'all, Bo

Sent from my SM-S908U using Tapatalk

[ChesterCopperpot]

I've always used that two part epoxy putty stick they sell in the marine section at Walmart. Let it set, sand it down.


Sent from my iPhone using Tapatalk

[RH1]

I've always used that two part epoxy putty stick they sell in the marine section at Walmart. Let it set, sand it down.


Sent from my iPhone using Tapatalk

Same here...