registration is free , easy and welcomed !!!
Started by Kygobblergetter, November 23, 2021, 02:44:01 PM
Quote from: guesswho on November 24, 2021, 09:28:51 AMI was hoping someone more proficient on suction yelpers would reply. I think sometimes people are hesitant to reply first to these type of threads. Hopefully others will chime in now after I go first. Keep in mind who this is coming from. Coming from someone far from an expert. The yelps sound muffled or to open to my ears. Sounds like the call needs to be pinched down either by lip placement or finger over the bell end, and probably both. Some suction yelps have more open internals than others and this can make it harder to manipulate the air and hit the higher notes. I'm hearing just a slight roll over from the high front end to the lower backend. By pinching off the airflow you might be able to hit the higher front end. Practice hitting and holding it first. Don't worry about the back end until you are satisfied with the front end. Once you can hit and hold it, then work on dropping off to the backend. I do this by slightly dropping my lower jaw while reducing airflow and pressure. The fast clucks/cutting sounds like your drawing way to much air and to long. I'm hearing a slightly drawn out cluck instead of the short pop. Also I know it was for the soundfile but to me that fast monotone pop pop pop doesn't sound natural. I think you need to reduce the amount of air pressure and reduce the length. I'd practice by first learning a real low volume cluck, then increase volume from there. And I'd get away from the monotone pop pop pop. I usually use 3 or 4 different volumes of clucks in a series and randomly spaced out. It may be something like POP——-pop, Pop———-pop—-pop. Once your satisfied with your tones listen to audio of real hens and mimic their cadence. Just like any call, you need cadence, tone and pitch. I don't know what trumpet you're using but I'd try a few different makers to see if one is easier for you versus others. What's easier for me, someone else may find more difficult and visa-versa. You are close to putting it all together. Just keep experimenting with pressures and lengths of airflow. Again this is coming from someone far from expert status. And hopefully more qualified others will add their comments now.