Quick ID on which side goes up on mouth calls.m

[Danger DAve]

Does anybody here put a marker on mouth calls to quickly determine which side goes up.  The tab ain't always visible and the tape ain't always marked with the logo of the producer.  I've noticed that Houndstooth calls have more aluminum visible on the part that goes down.  Maybe I'm over thing things.  I was thinking sharpy dot on the upside.

Sent from my XT1080 using Tapatalk

[Upfold99]

Longest reed goes up. The one that has the most significant cut in the latex.

[va longbeard]

The metal tab (i.e. bump) is another way to tell which way. 

The bump goes up against the roof of your mouth.

[Greg Massey]

Long on top , short on the bottom ...

[Crghss]

Can't hurt right? I could see marking it so during the heat of the moment a quick glance gets the correct side up (or down).

[Sir-diealot]

The metal tab (i.e. bump) is another way to tell which way. 

The bump goes up against the roof of your mouth.

Is that just for the mentioned maker? Most I have used say bump goes down.

[Greg Massey]

If you use one often enough , you real don't have to look at them ... you can tell with your tongue ..

[HookedonHooks]

The metal tab (i.e. bump) is another way to tell which way. 

The bump goes up against the roof of your mouth.

Is that just for the mentioned maker? Most I have used say bump goes down.

Some makers have bump on bottom, some on top. I prefer ones with a top bump, but as mentioned the reed length is usually the quickest visual tell.

If you use one often enough , you real don't have to look at them ... you can tell with your tongue ..

100% agree. You get to a point where you just pop it in your mouth and flip it over inside your mouth if it feels "off".

[Sir-diealot]

If you use one often enough , you real don't have to look at them ... you can tell with your tongue ..

This is how I tell.

[Spitten and drummen]

Longest reed on top always.

[GobbleNut]

Longest reed on top always.

In terms of how a call is supposed to be used, this is true all of the time.  However,...with some calls and some inexperienced callers, turning a call upside down can produce better sounds in rare cases. 

Long-time mouth call users that have learned to control air flow will pretty much invariably run calls long-reed-up. For newer guys, use the call the way it sounds the best to you,...and the turkeys!  Again, as has been said, they are supposed to be run long-reed-up.   

As for the tab up or down question, I guess some guys that construct calls might build them such that the tab is on the same side (up) as the long reed.  I have never built any that way and I can't ever remember seeing one that was.  Could happen though, I suppose...

[va longbeard]

The metal tab (i.e. bump) is another way to tell which way. 

The bump goes up against the roof of your mouth.

Is that just for the mentioned maker? Most I have used say bump goes down.

Lol thanks for correcting my mistake I got that backwards for sure,

I can just hear some one trying to run the call with the tab on their roof of there mouth sounding like their a dying rabit

[Sir-diealot]

The metal tab (i.e. bump) is another way to tell which way. 

The bump goes up against the roof of your mouth.

Is that just for the mentioned maker? Most I have used say bump goes down.

Lol thanks for correcting my mistake I got that backwards for sure,

I can just hear some one trying to run the call with the tab on their roof of there mouth sounding like their a dying rabit

You're welcome, I honestly was not trying to correct you though, thought it may be something different from the maker you use.