Camo my gun

[rosharb]

Has anyone used the camo tape that comes in a 6 inch by 7 foot roll I see on line? If so how was the finished product. Seems like a lot cheaper way to go as opposed to dipping.

[SKFOOTER]

Check out the Mossy Oak Graphics website.  They make kits specifically for guns and scopes.

[Tommyttapz]

I did my mossberg in the mossy oak wrap,  it looks AWESOME.  I'll take a pic tonight and post it! 


Sent from my iPhone using Tapatalk

[WhiteRook85]

Did my Mossberg 500 with the Mossy Oak Graphics Gun wrap/skin kit. Here's the before and after, looks almost like it was dipped.

Have a video out there with the installation of the wrap on a Remington 870.
Follow this link; https://www.youtube.com/watch?v=aFV9GXj2jyA

[rosharb]

When you wrap the barrel with a vent rib do you just wrap to the rib or try to fit it under the rib?

[WhiteRook85]

In the directions they tell you to just cut the material on either side of the rib. I did two with ribs, one I cut the wrap and fed it under the rib, works pretty good, just allow some extra time for that. The other I just cut a tad and have it about halfway under the rib. Both ways turned out fine, but if you have the extra time I would make the cuts and feed it all the way through the rib.

[deerbasshunter3]

Did my Mossberg 500 with the Mossy Oak Graphics Gun wrap/skin kit. Here's the before and after, looks almost like it was dipped.

Have a video out there with the installation of the wrap on a Remington 870.
Follow this link; https://www.youtube.com/watch?v=aFV9GXj2jyA

I know this is an old thread, but I was wondering how the wrap is holding up.