only use regular PayPal to provide purchase protection
Started by Longshanks, February 24, 2012, 06:54:50 PM
Quote from: Bad Grizzly on February 25, 2012, 08:45:15 AMTake your trigger assembly out and give it a good cleaning and light oiling.Once you put the B-Square mount on, you can't remove the trigger assembly unless you remove the B-Square bolts....... After several on/offs the bolt hex heads start rounding out.... might want to invest in a spare set of them.Also, if your using the typical style butt-stock and shooting 3.5" loads, you better watch the B-Square corner and your index finger.... they don't play well together. Split my finger open the very first shot.... after several more shots and my finger going numb.... I ordered a ShurShot stock set and never had another issue.
Quote from: Bad Grizzly on February 25, 2012, 08:42:23 PMIt should be able to fit any 12ga 870..... I'm pretty sure mine will fit them all anyway.Up to you on the D&T job.... if your not attached to it, maybe sell or trade it for one that is D&T'ed from the factory....If you have a friend in the machining business that you can trust to get everything square, I have the hole spacing measurements I measured off one of mine with a set of digital calipers.