After a couple of years using a red dot, I finally decided to go back to iron sights. I bought a Truglo Pro series magnum gobble dot. I think I'll really like the sight, and I mounted it last night. My question is, after mounting, I tried the rear windage and elevation adjustments. The elevation was a little tight, but moved once I got it broke loose. The windage however, is a different story. I backed the screw out (between the fiber optics) and can not get the sight to move. I even took the tiny screw out all the way, and still nothing. Almost like it's glued in place. Just wondering if anyone else has had this issue, and if so, do you have any suggestions.
Mine were easy to move both ways. Good luck.
Always liked mine and never had issue with them
Sent from my iPhone using Tapatalk
My guess is the set screw put a burr in the base and has it hung up!!!
Quote from: Dtrkyman on May 07, 2017, 09:10:48 PM
My guess is the set screw put a burr in the base and has it hung up!!!
I had a set do this. Tap with a small piece of brass. Then use a small flat file to clean it up.