Could I shoot Federal 3rd Degree shells through a lead only ulti-full choke in my 835?
Would be a good idea to use an HTL approved choke.
I don't see that it would really hurt anything. I know guy's that do.
If you don't mind shelling out the money for a new barrel if something does go wrong. If it's not rated for that shot no manufacturers will stand behind it. It's a pulling teeth thing when something happens and it is rated for it.
I thought 3'rd degree's was copper plated lead.
Quote from: turkeywhisperer935 on February 01, 2016, 02:35:53 AM
I thought 3'rd degree's was copper plated lead.
It's a blend that does contain some heavyweight.
I have a tightwad and SSX for the 835. With the flight control wad, it is hard to find a compatible choke. How about a factory full rated for steel shot?
Quote from: agent eight seven O on February 01, 2016, 01:20:59 PM
I have a tightwad and SSX for the 835. With the flight control wad, it is hard to find a compatible choke. How about a factory full rated for steel shot?
That would be fine.
Quote from: agent eight seven O on February 01, 2016, 01:20:59 PM
I have a tightwad and SSX for the 835. With the flight control wad, it is hard to find a compatible choke. How about a factory full rated for steel shot?
You've had very good advice about chokes and tungsten-based shot. The SSX does well with the 3rd Degree shells.
It's very important when evaluating the patterns with this shell to remember what the designer intended. It is intended to provide killing patterns at most reasonable ranges, including close (25 yards or less) and far (40 yards).
It's not mean to turn in the 10" numbers at 40 yards that you'll see from some shells but it never throws a "baseball" sized pattern, even at 25 yards. It's also important to look at the 20" patterns. They are often referred to as "halo" patterns.
Here's a link to the work that I did with those shells http://allaboutshooting.com/blogs/blog/98747719-federal-3rd-degree-evaluation-additional-information
You can see some actual patterns and a more detailed write-up of of those shells here http://allaboutshooting.com/blogs/blog/98747783-federal-3rd-degree-evaluation
Perspective is very important when evaluating these shells.
Thanks,
Clark