Print Page - 835 factory fiber optic sights need input on changing just to a bead

Title: 835 factory fiber optic sights need input on changing just to a bead
Post by: bigcountry25 on July 04, 2015, 07:11:07 PM

If you take the factor fiber optic sights off an 835 and install a bead would it be accurate? I have taken fiber sights off of one gun and it was way off.

Fibers optic sights are fine and dandy but if one breaks in the field your hunt is over with a bead sight I would have less to go wrong but I want to make sure that the 835 is just as accurate with a bead sight. It is pre threaded for a front bead sight

Thanks!!!

Title: Re: 835 factory fiber optic sights need input on changing just to a bead
Post by: dirt road ninja on July 04, 2015, 07:30:10 PM

I doubt the bead will shoot true, especially with an extended choke. Mine certainly doesn't.

Title: Re: 835 factory fiber optic sights need input on changing just to a bead
Post by: mwr on July 04, 2015, 09:42:48 PM

On my 835,my bead was off, that's why I put an FFIII on it

Title: Re: 835 factory fiber optic sights need input on changing just to a bead
Post by: Jimspur on July 04, 2015, 10:35:29 PM

Only way to know if it shoots to point of aim (POA)
is to try it with a bead.

Title: Re: 835 factory fiber optic sights need input on changing just to a bead
Post by: stinkpickle on July 05, 2015, 01:06:08 AM

All of my Mossberg barrels have shot low...or at least lower than I think they should. However, you won't know until you try.

Turkey hunting forum for turkey hunting tips

General Discussion => General Forum => Topic started by: bigcountry25 on July 04, 2015, 07:11:07 PM