Has anyone used the camo tape that comes in a 6 inch by 7 foot roll I see on line? If so how was the finished product. Seems like a lot cheaper way to go as opposed to dipping.
Check out the Mossy Oak Graphics website. They make kits specifically for guns and scopes. :OGturkeyhead:
I did my mossberg in the mossy oak wrap, it looks AWESOME. I'll take a pic tonight and post it!
Sent from my iPhone using Tapatalk
Did my Mossberg 500 with the Mossy Oak Graphics Gun wrap/skin kit. Here's the before and after, looks almost like it was dipped.
Have a video out there with the installation of the wrap on a Remington 870.
Follow this link; https://www.youtube.com/watch?v=aFV9GXj2jyA
When you wrap the barrel with a vent rib do you just wrap to the rib or try to fit it under the rib?
In the directions they tell you to just cut the material on either side of the rib. I did two with ribs, one I cut the wrap and fed it under the rib, works pretty good, just allow some extra time for that. The other I just cut a tad and have it about halfway under the rib. Both ways turned out fine, but if you have the extra time I would make the cuts and feed it all the way through the rib.
Quote from: WhiteRook85 on March 27, 2015, 08:03:53 AM
Did my Mossberg 500 with the Mossy Oak Graphics Gun wrap/skin kit. Here's the before and after, looks almost like it was dipped.
Have a video out there with the installation of the wrap on a Remington 870.
Follow this link; https://www.youtube.com/watch?v=aFV9GXj2jyA
I know this is an old thread, but I was wondering how the wrap is holding up.