OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

registration is free , easy and welcomed !!!

Main Menu

Franchi Rail Screw Hole Plug Search

Started by Trkmaster88, June 18, 2021, 10:28:59 AM

Previous topic - Next topic

Trkmaster88

Hey does anybody have any of the factory plastic screw holes plugs laying around they'd part with? I am looking for 4. Thanks!

Gmed


Trkmaster88

Quote from: Gmed on June 18, 2021, 01:14:11 PM
I believe they are 8-40 thread. You can order the little flat head blank filler screws from Brownells...

https://www.brownells.com/gunsmith-tools-supplies/small-hardware/metal-screws/plug-screw-kit-prod792.aspx

Thank you, and you are correct. Looking for the factory plastic ones. I feel they provide a cleaner look.

lacire


If my calipers and math are correct 8-40 screws are .16" in diameter = 4mm. I've never removed the ones in a Franchi receiver so the length and head diameter on these may be wrong, but take a look, may work may not. Somebody else may be able to point you in a better direction. If these should work for you please post back so anybody else looking will know. Good luck.

https://www.amazon.com/uxcell-Furniture-Plastic-Drilling-Insert/dp/B00X77ICCQ
Print by Madison Cline, on Flickr

Trkmaster88

Quote from: lacire on June 18, 2021, 08:20:33 PM

If my calipers and math are correct 8-40 screws are .16" in diameter = 4mm. I've never removed the ones in a Franchi receiver so the length and head diameter on these may be wrong, but take a look, may work may not. Somebody else may be able to point you in a better direction. If these should work for you please post back so anybody else looking will know. Good luck.

https://www.amazon.com/uxcell-Furniture-Plastic-Drilling-Insert/dp/B00X77ICCQ

Thanks for the link. I checked them out and the head diameter on there would be about twice as large (8mm vs a little over 4mm).

lacire

Quote from: Trkmaster88 on June 20, 2021, 09:29:10 PM
Quote from: lacire on June 18, 2021, 08:20:33 PM

If my calipers and math are correct 8-40 screws are .16" in diameter = 4mm. I've never removed the ones in a Franchi receiver so the length and head diameter on these may be wrong, but take a look, may work may not. Somebody else may be able to point you in a better direction. If these should work for you please post back so anybody else looking will know. Good luck.

https://www.amazon.com/uxcell-Furniture-Plastic-Drilling-Insert/dp/B00X77ICCQ

Thanks for the link. I checked them out and the head diameter on there would be about twice as large (8mm vs a little over 4mm).

Yah it's been awhile since I saw them and didn't remember how big the head was. Have you tried to contact Franchi?
Print by Madison Cline, on Flickr