I'm wanting to put the fastfire III on my new benelli super vinchi, what is the best way to mount it? The gun came drilled and tapped? Thanks
Not sure if the spacing is the same as the SBEII, but if I were to guess I would think it would be the same. I also have learned the spacing WILL NOT fit the 336 mount without redrilling. One option that makes a clean mount is to buy the Warne 2 piece steel bases made for SBEII, and utilize only one base with FF and picatelly mount.
Do you happened to have that part number? Thanks
This is the Warne number Midway USA shows. Once again I would make sure the SV has the same drill specs as the SBEII. Hope this helps.
Warne #: M894/870M
Out of stock just my luck....
If you can't get the 2 piece get the one peice warne a995m,look under remington 7400 1 piece mounts on midway,the rem 7400/7600 are the same pattern as the benelli sbe2,m2 and vinci/super vinci.i got mine from there for 12 bucks.Very nice mount comes with torx head screws and very low profile.Then you can either use it whole or cut it down to the length you need.
Thanks
Take a pic when you get it done.