OG shop member gallery
OldGobbler
          bullet Forum Board      bullet Pushpin Turkey Call Blog      bullet Advertising Info     

OG Gear Store
PATCHES


Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow






Author Topic: M3020 Question  (Read 1698 times)

Offline BigPimpin

  • Full Member
  • *
  • Posts: 82
M3020 Question
« on: April 09, 2019, 07:21:08 PM »
What’s the rib width on a 3020?  Thanks.
I'd rather be Drivin' > Disco.

Offline GomerPyle

  • Sr. Member
  • **
  • Posts: 105
Re: M3020 Question
« Reply #1 on: April 10, 2019, 11:29:11 AM »
Interested in this too, as I'm hopefully picking one up tomorrow and will want to put a set of rifle-style sights.  only thing I can find online says "topped with a 0.245" diameter ventilated rib...".  The fact that they referred to it as "diameter" makes me question if they actually know what they're talking about.  I'd like to hear from someone that owns one and can actually go measure it.
[From a buddy re: turkey hunting]
"the best advice I can give you is to run from it like it's crystal meth"

Offline Zeke6685

  • Hero Member
  • ***
  • Posts: 253
Re: M3020 Question
« Reply #2 on: April 10, 2019, 12:34:10 PM »
I had a set of the tru glo pro series on mine last year, the ones that fit were the 6mm. I believe the model # is TG944C. I have 2 used sets of these I’d make a good deal on them if anyone is interested.

Offline GomerPyle

  • Sr. Member
  • **
  • Posts: 105
Re: M3020 Question
« Reply #3 on: April 11, 2019, 10:40:39 PM »
Just got my 3020 and looks like 6mm is correct, but eyeballing it, 1/4" looks the same (although 1/4" is only 6.35mm, so it'd be hard to distinguish)
[From a buddy re: turkey hunting]
"the best advice I can give you is to run from it like it's crystal meth"

Online bwhana

  • Hero Member
  • ***
  • Posts: 314
Re: M3020 Question
« Reply #4 on: April 14, 2019, 11:04:52 AM »
Mine is .24 inches or 6mm +- a few hundredths

Offline joeturkey

  • Hero Member
  • ***
  • Posts: 273
Re: M3020 Question
« Reply #5 on: April 16, 2019, 07:40:58 AM »
Didn't like the vent rib mount had mine drilled and tapped

Offline joeturkey

  • Hero Member
  • ***
  • Posts: 273
Re: M3020 Question
« Reply #6 on: April 16, 2019, 08:05:16 AM »
This I the finished m3020 drilled and tapped with a fast fire  11 and cerakote paint job and  Rob Roberts  572 choke

Offline joeturkey

  • Hero Member
  • ***
  • Posts: 273
Re: M3020 Question
« Reply #7 on: April 16, 2019, 09:07:02 AM »
This is the mount you will need Burris #410333 .