OG shop member gallery
OldGobbler
          bullet Forum Board      bullet Pushpin Turkey Call Blog      bullet Advertising Info     

OG Gear Store

Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
DC Cattle Ranch






Author Topic: Winchester SXP Longbeard and Longbeard XR 3.5 #5s and three different chokes  (Read 2552 times)

Offline Thad

  • Jr. Member
  • *
  • Posts: 14
Shot my SXP with Winchester 12ga. using Longbeard XR 3.5 in #5s and here are the results with three different choke tubes:

Conditions:
 75 degrees with light wind.
barrel swabbed with a boresnake between shots
shots taken from a ledsled at 40 yards
pellet hits counted in a 10 inch circle

#1 Jebs Headhunter .650
170

#2 Carlsons Heavyshot .664
166

#3 Kicks Gobblin Thunder .680
134

What do y'all think?

Offline zelmo1

  • 2019 SITE SUPPORTER
  • Long Spur Gobbler
  • ********
  • Posts: 5162
  • Take a Newbie Hunting
Did you try the " Longbeard " choke that came with it?

Offline Thad

  • Jr. Member
  • *
  • Posts: 14
My fault this is the regular SXP not the  model that comes with that choke, so no.

However I did some research and the Carlsons Longbeard choke which i think is the one in question is a .665 and the one I tested is a .664.  I called the company and asked what the difference was and the guy pretty much said marketing.  I would not expect much of a difference in pattern.


Offline cibor

  • Jr. Member
  • *
  • Posts: 5
Sounds good to me, was the pattern even/without holes?

This is what my SXP managed:

Temp 67 degrees
Hevi shot #7
40 yrds

Strangler .665 - 10" circle - 189

-Scott T.

Offline tracker#1

  • 2020 SITE SUPPORTER
  • Hero Member
  • ********
  • Posts: 285
  • Big game tracker with dogs, Oathkeeper, NRA Endowm
I have a picture posted using a long beard Carlson's choke .665  It patterned better then stock choke in my opinion, someone just posted on forum it looked good for #5s LBs