Cutting..

[jwright8]

What surface do you prefer to cut on? Glass/crystal, aluminium, etc.?

Thanks

Sent from my VS986 using Tapatalk

[mwr]

I like crystal the best. But then again I like them all!!

[greentag]

i like them all,if i had to pick just one, probably aluminum.

[Double B]

I like glass and ceramic.   

[Bowguy]

If you're looking to locate especially, I like aluminum than Crystal/glass

[870BkWht]

For me, ceramic and crystal makes the best surface to produce cuts on. I also think crystal makes the most realistic sounding calls

[Sadler McGraw]

Slate with a Quaker boy carbon striker. Slate with Dymonwood or slate with Hickory( angle tip)

[outdoors]

   SLATE

[Double B]

Was curious to see how this was panning out.   Many good choices out there.  Cool, I don't have to stop picking up new calls to try now!  It is kind of situational, and you can do it with many calls.  Good stuff.   

[mgm1955]

IMO crystal.

[Bowguy]

Was curious to see how this was panning out.   Many good choices out there.  Cool, I don't have to stop picking up new calls to try now!  It is kind of situational, and you can do it with many calls.  Good stuff.

You can do it with any call.

[M,Yingling]

to get that nice little higher pitched cut copper ...couple of quick cuts and a raspy yelp gets them goblin every time

[MK M GOBL]

Use my slate and will switch it up to a glass every once in a while.

MK M GOBL

[Stump.270]

I would listen to Sadler he may know what he's talking about I use a slate with Paduk or crystal mistress with woodhaven strike 3


Sent from my iPhone using Tapatalk

[JLH]

Titanium with a katalox or ebony striker.....titanium is very "grippy" and makes it easy to cut.