OG shop member gallery
OldGobbler
          bullet Forum Board      bullet Pushpin Turkey Call Blog      bullet Advertising Info     

OG Gear Store
PATCHES


Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow






Author Topic: Lathe chuck for turning small diameter  (Read 1420 times)

Offline magnumgray

  • Full Member
  • *
  • Posts: 78
Lathe chuck for turning small diameter
« on: November 17, 2022, 03:01:14 PM »
  What's a good  4 jaw lathe chuck that will handle 3/4 stock without costing a fortune.... there are a lot that handle 1" stock but what to use standard  finished stock

Offline mmclain

  • Hero Member
  • ***
  • Posts: 444
Re: Lathe chuck for turning small diameter
« Reply #1 on: November 18, 2022, 09:57:19 PM »
Buy a smaller set of jaws.   Don’t get a el cheapo chuck.