OG shop member gallery
OldGobbler
          bullet Forum Board      bullet Pushpin Turkey Call Blog      bullet Advertising Info     

OG Gear Store

Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
DC Cattle Ranch






Author Topic: Remington 1187 20 ga plug  (Read 130 times)

Offline Oldmason

  • Jr. Member
  • *
  • Posts: 6
Remington 1187 20 ga plug
« on: September 03, 2021, 02:56:44 PM »
I need a plug to limit shells to 2 in magazine and 1 in chamber

Offline Gmed

  • Hero Member
  • ***
  • Posts: 278
Re: Remington 1187 20 ga plug
« Reply #1 on: September 03, 2021, 07:30:51 PM »
Unless you are just adamant about the factory plug, run down to ya local hardware store and get you a 3/8 or 1/2 inch dowel rod and cut to length….works just as well.

Offline Oldmason

  • Jr. Member
  • *
  • Posts: 6
Re: Remington 1187 20 ga plug
« Reply #2 on: September 04, 2021, 02:00:52 PM »
Yep that's what I had decided to do. Thanks

Offline tnanh

  • Hero Member
  • ***
  • Posts: 394
Re: Remington 1187 20 ga plug
« Reply #3 on: September 13, 2021, 10:59:01 PM »
Sometimes, even the factory plug makes noise when you rock the muzzle back and forth, I have added the slip in pencil erasers on each end to fix this problem but only on a mossberg 500, Bought a dowel the same size as a pencil and kept trimming the length a small amount at a time until the length was right. I think I had to smooth the erasers with sand paper to fit a little better. Worked fine with a little trial and error and was quiet.