I purchased some latex for tube calls (bulk) and I have a rotary cutter tool. Do I just use a straight edge and rotary cutter? Also wondering if it matters if I play the call on the cut edge vs factory edge. Thanks, I couldn't find any threads for cutting your own latex.
Straight edge and rotary cutter. If it's Straight it will not matter which side.
Have a good one
Bo
Sent from my SM-N986U using Tapatalk
Just what I was after, thanks.
Quote from: milertyme03 on April 26, 2022, 09:39:40 AM
I purchased some latex for tube calls (bulk) and I have a rotary cutter tool. Do I just use a straight edge and rotary cutter? Also wondering if it matters if I play the call on the cut edge vs factory edge. Thanks, I couldn't find any threads for cutting your own latex.
I run tube calls 99.9% of the time. After cutting my latex with scissors for 27 years I just recently purchased a rotary cutter. Best thing I ever did!
Back to your question...cut edge or factory edge will both work fine. I have found that when cutting with scissors sometimes my cuts we jagged but still ran good on a call.