Wingbone practice

[HillclimberWV]

I tried to post a picture and keep getting an error for failed security check. Ive never had that problem before and i sized it down as small as possible only 50kb

[HillclimberWV]

Here is the pic thanks to oldgobbler.

[HillclimberWV]

All three calls are from gobblers. One is smoothed with jb weld the other two are poorly thread wrapped. They were also stained to try and knock the white from bleaching down. All three have epoxy in the mouth piece. Still have the bone to make the 2 piece into a three piece but wanet to experiment.

[crow]

Looking good, nice joint transition on the green 3 piece

[EZ]

Nice!!!
The little three bone "looks" like it would play pretty good. I would have left a little more length on the bell. Sometimes, if they're too short you don't get a good roll-over.

It's fun experimenting.

[HillclimberWV]

Thanks for the advice. Im going to keep playing with them may keep changing them as i go.

[HillclimberWV]

Made a couple more wingbones over winter and have taken a liking to this one.

https://on.soundcloud.com/RhYpu

Sent from my SM-S906U using Tapatalk